CSE 466 Lab 1- AU03

1. In “Downloading, Installing and Configuring WinAVR”—

Read the sections on Makefiles, Setting Up Programmers Notepad, and Your First WinAVR Project. Do the set-up, noting the tool changes in this document.

2. Compile the code shown in Your First WinAVR Project. Note the changes.

3. Wire the schematic as shown in this document, and ask a TA to check it.

4. Try downloading your compiled code. If done correctly, the decimal point should blink.

5. Demonstrate your completed set-up to a TA.

Programming Tool Changes:

Tools should look like this:

Program:

Note PORTB.0 change…(PORTB.0 is connected to the LED Decimal Point.)